Nissan Rogue Service Manual: DTC/circuit diagnosis
- C1101, C1102, C1103, C1104 wheel sensor
- C1105, C1106, C1107, C1108 wheel sensor
- C1109 power and ground system
- C1111 pump motor
- C1113, C1145, C1146 yaw rate/side/decel G sensor
- C1115 ABS sensor [abnormal signal]
- C1120, C1122, C1124, C1126 ABS in valve system
- C1121, C1123, C1125, C1127 ABS out valve system
- C1130 engine signal
- C1140 actuator relay system
- C1142 press sensor
- C1143 steering angle sensor
- C1144 incomplete steering angle sensor adjustment
- C1155 brake fluid level switch
- C1160 DECEL G SEN SET
- C1164, C1165 CV system
- C1170 variant coding
- C1197 vacuum sensor
- C1198 vacuum sensor
- C1199 brake booster
- C119A vacuum sensor
- U1000 CAN COMM CIRCUIT
- Power supply and ground circuit
- Parking brake switch
- VDC off switch
- ABC warning lamp
- Brake warning lamp
- VDC warning lamp
- VDC off indicator lamp
Calibration of decel G sensor
Description
CAUTION:
Always perform the decel G sensor calibration before driving when the following
operation is performed.
NOTE:
Yaw rate/side/decel G sensor calibration is performed when pe ...
C1101, C1102, C1103, C1104 wheel sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1101
RR RH SENSOR-1
When power supply voltage of rear wheel sen ...
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT
PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Symptom diagnosis
SQUEAK AND RATTLE TROUBLE DIAGNOSES
Work Flow
CUSTOMER INTERVIEW
Interview the customer if possible, to determine the conditions that exist
when the noise occurs. Use the Diagnostic
Worksheet during the interview to document the facts and conditions when the
noise occurs and any
custome ...
EPS warning lamp does not turn off
Description
EPS warning lamp does not turn OFF several seconds after engine started.
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT
Turn the ignition switch OFF to ON.
Perform “EPS” self-diagnosis.
Is any DTC detected?
YES >> Check the DTC. Refer to STC ...
