Component Function Check
1.CHECK VDC WARNING LAMP FUNCTION
Check that VDC warning lamp in combination meter turns ON for 1 second after ignition switch is turned ON.
CAUTION: Never start the engine. Is the inspection result normal? YES >> Inspection End.
NO >> Proceed to BRC-122, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit.
Refer to BRC-122, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace error-detected parts.
2.PERFORM THE SELF-DIAGNOSIS
With CONSULT
CAUTION:
Is any DTC detected? YES >> Check the DTC. Refer to BRC-55, "DTC Index".
NO >> GO TO 3.
3.CHECK VDC WARNING LAMP SIGNAL
With CONSULT
CAUTION: Never start the engine. Is the inspection result normal? YES >> Replace the combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Replace the ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".
Brake warning lamp
VDC off indicator lampInterior light
Interior light
When the ON switch 1 is pressed, the footwell
lights (if so equipped), step lights (if so
equipped), map lights and rear personal lights
will automatically turn on and stay on for a period
of time when:
The doors are unlocked by the Intelligent
Key, a key or the r ...
Body side trim
Exploded View
Front pillar finisher
Front body side welt
Center pillar upper finisher
Rear body side welt
Rear kicking plate
Seat belt cover
Center pillar lower finisher
Front kicking plate
Dash side finisher
Pawl
Clip
Front
FRONT PILLAR FINISHER
...
Removal and installation
HOOD
Exploded View
Hood hinge (RH)
Hood
Hood side seal
Hood front seal
Hood center seal
Bumper rubber
Hood insulator
Hood rod clamp
Hood support rod
Hood rod grommet
Hood hinge (LH)
HOOD ASSEMBLY
HOOD ASSEMBLY : Removal and Instal ...