Nissan Rogue Service Manual: ABC warning lamp
Component Function Check
1.CHECK ABS WARNING LAMP FUNCTION
Check that ABS warning lamp in combination meter turns ON for 1 second after ignition switch is turned ON.
CAUTION: Never start the engine.
Is the inspection result normal? YES >> Inspection End.
NO >> Proceed to BRC-119, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit.
Refer to BRC-119, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace error-detected parts.
2.PERFORM SELF-DIAGNOSIS
With CONSULT
- Turn the ignition switch OFF → ON.
CAUTION:
- Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
- Start the engine.
- Repeat step 1 two or more times.
- Perform self-diagnosis for “ABS”.
Is any DTC detected? YES >> Check the DTC. Refer to BRC-55, "DTC Index".
NO >> GO TO 3.
3.CHECK ABS WARNING LAMP SIGNAL
With CONSULT
- Select “ABS”, “DATA MONITOR” and “ABS WARN LAMP” according to this order.
- Turn the ignition switch OFF.
- Check that data monitor displays “On” for 1 second after ignition switch is turned ON and then changes to “Off”.
CAUTION: Never start the engine. Is the inspection result normal? YES >> Replace the combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Replace the ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".
VDC off switch
Component Function Check
1.CHECK VDC OFF SWITCH OPERATION
Check that VDC OFF indicator lamp in combination meter turns ON/OFF when VDC
OFF switch is operated.
Is the inspection result normal?
...
Brake warning lamp
Component Function Check
1.CHECK BRAKE WARNING LAMP FUNCTION
Check that brake warning lamp in combination meter turns ON for 1 second
after ignition switch is turned ON.
CAUTION:
Never start t ...
Other materials:
Rear stabilizer
Exploded View
Rear stabilizer bar
Connecting rod (RH)
Rear stabilizer bar bushing
Rear stabilizer bar clamp
Connecting rod (LH)
Front
Removal and Installation
REMOVAL
Disconnect rear stabilizer links from rear stabilizer bar.
...
System description
COMPONENT PARTS
Component Parts Location
Instrument lower panel LH
Rear final drive assembly
Rear wheel house outer panel in luggage
room of left side
No.
Component
Function
1
Combination meter
Mainly transmits the following signals to AWD control unit ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
