Nissan Rogue Service Manual: VDC off indicator lamp
Component Function Check
1.CHECK VDC OFF INDICATOR LAMP FUNCTION (1)
Check that VDC OFF indicator lamp in combination meter turns ON for 1 second after ignition switch is turned ON.
CAUTION: Never start the engine. Is the inspection result normal? YES >> GO TO 2.
NO >> Proceed to BRC-123, "Diagnosis Procedure".
2.CHECK VDC OFF INDICATOR LAMP FUNCTION (2)
Check that VDC OFF indicator lamp in combination meter turns ON/OFF when VDC OFF switch is operated.
Is the inspection result normal? YES >> Inspection End.
NO >> Check the VDC OFF switch system. Refer to BRC-117, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) POWER SUPPLY AND GROUND CIRCUIT
Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit.
Refer to BRC-123, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace error-detected parts.
2.CHECK VDC OFF INDICATOR LAMP SIGNAL
With CONSULT
- Select “ABS”, “DATA MONITOR” and “OFF LAMP” according to this order.
- Turn the ignition switch OFF.
- Check that data monitor displays “On” for 1 second after ignition switch is turned ON, and then changes to “Off”.
CAUTION: Never start the engine. Is the inspection result normal? YES >> GO TO 3.
NO >> Replace the ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".
3.CHECK VDC OFF INDICATOR LAMP SIGNAL
With CONSULT
- Select “ABS”, “DATA MONITOR” and “OFF LAMP” according to this order.
- Check that data monitor displays “On” or “Off” each time when VDC OFF switch is operated.
Is the inspection result normal? YES >> Replace the combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Check the VDC OFF switch system. Refer to BRC-117, "Diagnosis Procedure".
VDC warning lamp
Component Function Check
1.CHECK VDC WARNING LAMP FUNCTION
Check that VDC warning lamp in combination meter turns ON for 1 second after
ignition switch is turned ON.
CAUTION:
Never start the e ...
Other materials:
Basic inspection
CONFIGURATION (CAN GATEWAY)
Work Procedure
1.WRITING MODE SELECTION
CONSULT Configuration
Select “Re/programming, Configuration” of CAN gateway.
When writing saved data>>GO TO 2.
When writing manually>>GO TO 3.
2.PERFORM “AFTER REPLACE ECU” OF “READ / WRITE CONFIGURA ...
System
System Description
SYSTEM DIAGRAM
OPERATION DESCRIPTION
When rear window defogger switch is turned ON while ignition
switch is ON, the rear window defogger
switch transmits rear window defogger switch signal to BCM.
BCM turns rear window defogger relay ON when rear windo ...
P155D generator
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P155D
GENERATOR
(Generator)
ECM receives mechanical malfunction signal sent from generator.
ECM receives electrical malfunction ...
