Nissan Rogue manuals

Nissan Rogue Service Manual: C1113, C1145, C1146 yaw rate/side/decel G sensor

Nissan Rogue Service Manual / Brakes / Brake Control System / DTC/circuit diagnosis / C1113, C1145, C1146 yaw rate/side/decel G sensor

DTC Display Item Malfunction detected condition Possible causes
C1113 G SENSOR When a malfunction is detected in longitudinal G sensor signal.
  • Harness or connector
  •  Yaw rate/side/decel G sensor • ABS actuator and electric unit (control unit)
  •  Ignition power supply system
  •  Fuse
C1145 YAW RATE SENSOR
  • When a malfunction is detected in yaw rate signal.
  •  When yaw rate signal is not continuously received for 2 seconds or more.
  •  When side G signal is not continuously received for 2 seconds or more.
  •  When decel G signal is not continuously received for 2 seconds or more.
C1146 SIDE G-SEN CIRCUIT When a malfunction is detected in side/decel G signal.

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

  1.  Turn ignition switch OFF to ON.
  2.  Perform self diagnostic result.

Is DTC C1113, C1145 or C1146 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-84, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Replace ABS actuator and electric unit (control unit).

>> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".

C1111 pump motor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1111 PUMP MOTOR When a malfunction is detected in motor or motor relay. ...

C1115 ABS sensor [abnormal signal]
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1115 ABS SENSOR [ABNORMAL SIGNAL] When difference in wheel speed betw ...

Other materials:

Service data and specifications (SDS)
BODY ALIGNMENT Body Center Marks mark has been placed on each part of the body to indicate the vehicle center. When repairing parts damaged by an accident which might affect the vehicle frame (members, pillars, etc.), more accurate and effective repair will be possible by using these marks t ...

ECU diagnosis information
BCM Reference Value NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.  Activate and display TPMS sensor IDs  Display tire pressure reported by the TPMS sensor  Read T ...

Sensor maintenance
Sensor maintenance The distance sensor for the FCW system A is located behind the front bumper. To keep the FCW system operating properly, be sure to observe the following:  Always keep the sensor area of the front bumper clean.  Do not strike or damage the areas around ...

© 2014-2026 Copyright t32.nirogue.com