Nissan Rogue Service Manual: C1142 press sensor
DTC Logic
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction detected condition | Possible causes |
| C1142 | PRESS SEN CIRCUIT | When a malfunction is detected in master cylinder pressure sensor |
|
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT.
- Turn ignition switch OFF to ON.
- Perform self-diagnostic result.
Is DTC C1142 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-94, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.CHECK STOP LAMP SWITCH SYSTEM
Check stop lamp switch system. Refer to BR-7, "Inspection".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace malfunctioning components.
2.CHECK BRAKE FLUID LEAKAGE
Check brake fluid leakage. Refer to BR-8, "Inspection".
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace malfunctioning components.
3.CHECK BRAKE PEDAL
Check brake pedal. Refer to BR-7, "Inspection".
Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace malfunctioning components.
4.CHECK HYDRAULIC BOOSTER ASSEMBLY
Check hydraulic booster assembly. Refer to BR-10, "Inspection".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace malfunctioning components.
5.CHECK SELF DIAGNOSTIC RESULT
With CONSULT.
- Turn ignition switch OFF to ON.
- Perform self-diagnostic result.
- Erase DTCs.
- Start engine and drive vehicle for a short period of time.
- Turn ignition switch OFF to ON.
- Perform self-diagnostic result.
Is DTC C1142 detected? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".
NO >> Inspection End.
C1140 actuator relay system
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1140
ACTUATOR RLY
When a malfunction is detected in actuator relay.
...
C1143 steering angle sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1143
ST ANG SEN CIRCUIT
When a malfunction is detected in steering angle ...
Other materials:
P0441 EVAP control system
DTC Description
DTC DETECTION LOGIC
In this evaporative emission (EVAP) control system, purge flow occurs during
non-closed throttle conditions.
Purge volume is related to air intake volume. Under normal purge conditions
(non-closed throttle), the EVAP
canister purge volume control solenoi ...
Front seat belt
Exploded View
Seat belt height adjuster (RH)
Seat belt height adjuster bolt
cover (RH)
Seat belt retractor (RH)
Seat belt buckle (RH)
Seat belt buckle (LH)
Seat belt retractor (LH)
Seat belt height adjuster bolt
cover (LH)
Seat belt height adjuster (LH)
SEAT BELT RETR ...
Map lights
Map lights
Push the button to turn the map lights on. To turn
them off, press the button again.
CAUTIONDo not use for extended periods of time
with the engine stopped. This could result
in a discharged battery.
Personal Lights (if so equipped)
Rear personal lights
To tu ...
