Nissan Rogue Service Manual: Electrical & power control
- Power Outlet
- Precaution
- System description
- Wiring diagram
- Removal and installation
- Service data and specifications (SDS)
- Body Control System
- LAN System
- CAN fundamental
- CAN
- CAN gateway
- CAN system (type 1)
- CAN system (type 2)
- CAN system (type 3)
- CAN system (type 4)
- CAN system (type 5)
- CAN system (type 6)
- CAN system (type 7)
- CAN system (type 8)
- Power Control System
- Charging System
- Precaution
- Preparation
- System description
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Symptom diagnosis
- Removal and installation
- Service data and specifications (SDS)
- Power Supply, Ground & Circuit Elements
Removal and installation
HORN
Exploded View
Horn (LOW)
Horn (HIGH)
Removal and Installation
REMOVAL
Horn (LOW)
Remove the front grille. Refer to EXT-23, "Removal and
Installation".
&n ...
Power Outlet
...
Other materials:
P0127 IAT sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0127
IAT SENSOR-B1
(Intake air temperature too high)
Rationally incorrect voltage from the sensor is sent to ECM,
compared with
the voltage ...
Wind deflector
Removal and Installation
REMOVAL
Remove headlining Refer to INT-30, "Removal and Installation".
Open the glass lid to view the wind deflector.
Use suitable tool (A) release pawl on LH/RH side of wind deflector.
: Pawl
Release wind deflector retainer (1) ...
Under cover
Exploded View
Floor under cover (RH)
Engine under cover
Floor under cover (LH)
ENGINE UNDER COVER
ENGINE UNDER COVER : Removal and Installation
REMOVAL
Remove engine under cover clips.
Remove engine under cover.
INSTALLATION
Installation is in the reverse ord ...
