Nissan Rogue Service Manual: Removal and installation

Fusible link inspection

How To Check A melted fusible link can be detected either by visual inspection or by feeling with finger tip. If its condition is questionable, use circuit tester or test lamp. Fusible lin ...

Battery

Exploded View Battery tray liner Battery frame Battery  Battery rod Battery cover Battery tray Front Removal and Installation (Battery) REMOVAL  Pull back cov ...

Other materials:

Loading tips
The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./C.M.V.S.S. certification label. Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR. WARNING  Properly secure all cargo with ropes or straps to help prevent it fro ...

Meter control switch signal circuit
Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-32, "Wiring Diagram". 1.CHECK METER CONTROL SWITCH SIGNAL  Turn ignition switch ON.  Check voltage between the following terminals of the meter control switch harness connector M3. Is the ins ...

Room lamp
Removal and Installation WARNING: Do not touch the glass surface of a bulb while it is lit or right after being turned OFF to prevent burns. CAUTION:  Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from bulb surface.  Do not le ...