Nissan Rogue Service Manual: DTC/circuit diagnosis
- B0001, B0002 driver airbag module
- B0010, B0011 passenger airbag module
- B0020 side airbag module IH
- B0028 side airbag module RH
- B0021 side curtain air bag module IH
- B0029 side curtain air bag module RH
- B1430 seat belt pre-tensioner
- B1431 seat belt pre-tensioner
- B1428 seat belt buckle switch IH
- B1429 seat belt buckle switch RH
- B0094 crash zone sensor
- B0093 front door satellite sensor LH
- B0098 front door satellite sensor RH
- B0091 front side air bag satellite sensor LH
- B0096 front side air bag satellite sensor RH
- B0092 rear side air bag satellite sensor LH
- B0097 rear side air bag satellite sensor RH
- B00A0 OCS system
- B14XX air bag diagnosis sensor unit
- B00D5 front passenger air bag off indicator
- B142A ignition voltage
- U1000 CAN COMM circuit
- U1010 control unit (CAN)
- B142X collision detection
Intermittent incident
Inspection Procedure
INTERMITTENT TROUBLE
An intermittent incident may have occurred in the past but is not being
detected currently. This DTC will not be
detected on SELF-DIAG [CURRENT], but may ...
B0001, B0002 driver airbag module
DTC Logic
DTC DETECTION LOGIC
CONSULT name
DTC
DTC detecting condition
Repair order
DRIVER AIRBAG MODULE CIRCUIT
[OPEN]
B0001
Driver air bag module ...
Other materials:
CAN system (type 1)
DTC/CIRCUIT DIAGNOSIS
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and
loose connecti ...
ID registration procedure
Description
This procedure must be performed after replacement of a tire pressure sensor
or BCM.
Work Procedure
TPMS ID registration can be performed using one of the following procedures:
Transmitter Activation tool [KV48105501 (J-45295-A)] with CONSULT
(preferred method)
...
Removal and installation
DRIVE PINION OIL SEAL
Exploded View
Rear final drive assembly
Drive pinion oil seal
Electric controlled coupling assembly
Oil seal lip
Always replace after every
disassembly.
: Apply gear oil.
: Apply multi-purpose grease.
Removal and Installation
REMOVAL
Remove ...
