Nissan Rogue Service Manual: B142X collision detection

Nissan Rogue Service Manual / Restraints / SRS Airbag Control System / DTC/circuit diagnosis / B142X collision detection

Description

DTC B1209 - B1211 COLLISION DETECTION

The air bag diagnosis sensor unit will set this DTC if it has detected a collision which has resulted in a deployment of one or more air bags or pre-tensioners. If this DTC is detected after a SRS repair, the air bag diagnosis sensor unit has not yet been replaced. This DTC can not be erased.

PART LOCATION

Refer to SRC-6, "Component Parts Location".

DTC Logic

DTC DETECTION LOGIC

With CONSULT

CONSULT name	DTC	DTC detecting condition	Repair order
FRONTAL COLLISION DETECTION	B1421	Frontal collision detected. Driver and/or front passenger air bag modules are deployed.	Refer to SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a collision" or SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision".
SIDE COLLISION DETECTION	B1422	Side collision detected. Curtain air bag module and seat belt pre-tensioner are deployed	Refer to SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision" or SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision"

DTC CONFIRMATION PROCEDURE (With CONSULT)

1.INSPECTION START

Turn ignition switch ON.

>> GO TO 2.

2.CHECK SELF-DIAG RESULT

Check for the DTC on CONSULT.

Is the DTC detected? YES >> Refer to SRC-97, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

Refer to Frontal collision: SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a collision", SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision" or SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision" or Side and rollover collision: SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision"

U1010 control unit (CAN)

Description Air bag diagnosis sensor performs self-tests on key ON. If CAN communication failure within control unit is detected, DTC is set. DTC Logic DTC DETECTION LOGIC CONSULT na ...

Symptom diagnosis

...

Other materials:

The fuel gauge does not move
Description Fuel gauge does not move from a certain position. Diagnosis Procedure 1.CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE Perform the self-diagnosis mode of combination meter, and then check that the fuel gauge operates normally. Refer to MWI-19, "Description". I ...

Operation
Switch Name and Function STEERING SWITCH No. Switch name Operation Description 1 Enter/Up/Down switch Press The information display settings can be changed. 2 Display switch 3 Back switch METER CONTROL SWITCH No. Sw ...

Active trace control
This system senses driving based on the driver’s steering and acceleration/braking patterns, and controls brake pressure at individual wheels to aid tracing at corners and help smooth vehicle response. The Active Trace Control can be set to ON (enabled) or OFF (disabled) through the Vehicl ...