Nissan Rogue Service Manual: U1010 control unit (CAN)
Description
Air bag diagnosis sensor performs self-tests on key ON. If CAN communication failure within control unit is detected, DTC is set.
DTC Logic
DTC DETECTION LOGIC
|
CONSULT name |
DTC |
DTC detecting condition |
Repair order |
| CAN CONTROL UNIT FAILURE | U1010 | CAN communication error is detected in control unit. | Refer to SRC-96, "Diagnosis Procedure". |
DTC CONFIRMATION PROCEDURE
1.PERFORM SELF-DIAGNOSIS
- Turn ignition switch ON.
- Using CONSULT, perform SELF DIAGNOSIS RESULTS of AIR BAG.
- Check if DTC is displayed in the self-diagnosis results.
Is DTC detected? YES >> Refer to SRC-96, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.REPLACE AIR BAG DIAGNOSIS SENSOR UNIT
Replace air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation".
>> Inspection End.
U1000 CAN COMM circuit
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and exce ...
B142X collision detection
Description
DTC B1209 - B1211 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a deployment
of one or more air bags or ...
Other materials:
NISSAN Intelligent Key® battery discharge
(if so equipped)
NISSAN Intelligent Key® battery discharge
If the battery of the NISSAN Intelligent Key® is
discharged, or environmental conditions interfere
with the Intelligent Key operation, start the engine
according to the following procedure:
Place the shift lever in the P (Park) position.
...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
C1708, C1709, C1710, C1711 transmitter (no data)
DTC Logic
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTC ...
