Nissan Rogue Service Manual: Removal and installation

Rear disc brake

Brake Burnishing CAUTION:  Burnish contact surfaces between brake pads and disc brake rotor according to the following procedure after refinishing the disc brake rotor, replacing brake ...

Brake pedal

Exploded View Rivet Clevis pin Brake pedal  Brake pedal pad Clip Snap pin  Stop lamp switch  Brake pedal position switch Removal and Installation REMOVAL ...

Other materials:

Air bag diagnosis sensor unit
Exploded View Diagnosis sensor unit Front Removal and Installation WARNING:  Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait at least three minutes.  Before disconnecting the air bag diagnosis sensor unit harness ...

Charging system preliminary inspection
Diagnosis Procedure 1.CHECK BATTERY TERMINALS CONNECTION Check if battery terminals are clean and tight. Is the inspection result normal? YES >> GO TO 2. NO >> Repair battery terminal connection. Confirm repair by performing complete Charging system test using EXP-800 NI or G ...

P0456 EVAP control system
DTC Description DTC DETECTION LOGIC This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease of fuel temperature in the fuel tank after turning ignition switch OFF. If ECM judges t ...