Nissan Rogue Owners Manual: Outside mirrors

Nissan Rogue Owners Manual / Pre-driving checks and adjustments / Mirrors / Outside mirrors

Outside mirrors

The outside mirror remote control will operate only when the ignition switch is in the ACC or ON position.

Move the small switch 1 to select the right or left mirror. Adjust each mirror to the desired position using the large switch 2 .

WARNING

Objects viewed in the outside mirror on the passenger side are closer than they appear. Be careful when moving to the right. Using only this mirror could cause an accident. Use the inside mirror or glance over your shoulder to properly judge distances to other objects.
Do not adjust the mirrors while driving.
You could lose control of your vehicle and cause an accident.

Manual folding outside mirrors

Pull the outside mirror toward the door to fold it.

Heated mirrors (if so equipped)

Some outside mirrors can be heated to defrost, defog, or de-ice for improved visibility. For additional information, refer to “Rear window and outside mirror (if so equipped) defroster switch” in the “Instruments and controls” section of this manual.

Automatic Anti-glare rearview mirror (if so equipped)

Automatic Anti-glare rearview mirror (if so equipped) The inside mirror is designed so that it automatically dims during night time conditions and according to the intensity of the headlights ...

Monitor, climate, audio, phone and voice recognition systems

WARNING Positioning of the heating or air conditioning controls and display controls should not be done while driving in order that full attention may be given to the ...

Other materials:

C1716, C1717, C1718, C1719 transmitter (pressure data)
DTC Logic NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS sensor IDs Display tire pressure reported by the TPMS sensor Read TPMS DTC ...

DTC/circuit diagnosis
DOOR MIRROR REMOTE CONTROL SWITCH (MIRROR SWITCH/ CHANGEOVER SWITCH) Component Inspection 1.CHECK MIRROR SWITCH & CHANGEOVER SWITCH Turn ignition switch OFF. Disconnect door mirror remote control switch connector. Check door mirror remote control switch. Is th ...

Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.CHECK SYMPTOM ...