To make a call from a phone connected to the vehicle’s Bluetooth® Hands-Free Phone System:
button.Say “Call”.
For 7- and 10-digit phone numbers, speak the numbers. When finished, say “Dial” to initiate the call. Say “Correction” at any time in the process to correct a misspoken or misinterpreted number.
For phone numbers with more digits or special characters, say “Special Number”, then speak the digits. Up to 24 digits can be entered. Available special characters are “star”, “pound”, “plus” and “pause”. When finished, say “Dial” to initiate the call. Say “Correction” at any time in the process to correct a misspoken or misinterpreted number or character.
The name of the phonebook entry will be displayed if it available, otherwise the number being redialed will be displayed.
Receiving a call
When a call is received by the phone connected to the vehicle’s Bluetooth® Hands-Free Phone System, the call information is displayed on either the vehicle information display or both the vehicle information display and the control panel display.
Press the
button to accept the
call. Press
the
button to reject the call.
During a call
While a call is active, press the
button to
access additional options. Speak one of the following
commands:
button and confirm
when
prompted.If supported by the phone, the Bluetooth®
Hands-Free Phone System allows for call waiting
functionality. If a call is received while another call
is already active, a message will be displayed on
the screen. Press the
button to
hold the
active call and switch to the second call. Press
the
button to reject the second
call.
While the second call is active, pressing
the
button will allow the same
commands
that available during any call as well as two additional
commands:
Press the
button to accept the
call. Press
the
button to reject the call.
Ending a call
To end an active call, press the
button
Voice commands
Text messagingDTC/circuit diagnosis
U1000 CAN COMM CIRCUIT
Description
Refer to LAN-8, "System Description".
DTC Logic
DTC DETECTION LOGIC
NOTE:
U1000 can be set if a module harness was disconnected and reconnected, perhaps
during a repair. Confirm
that there are actual CAN diagnostic symptoms and a present DTC by p ...
Battery
Keep the battery surface clean and dry.
Clean the battery with a solution of baking
soda and water.
Make certain the terminal connections are
clean and securely tightened.
If the vehicle is not to be used for 30 days or
longer, disconnect the negative (-) battery
termina ...
Front and rear washer motor
Exploded View
Washer tank
Front and rear washer motor
Rear view camera washer motor
Seal
Rear washer outlet
Front washer out
Removal and Installation
REMOVAL
Drain washer fluid.
Remove front fender protector (RH). Refer to EXT-28, "FENDER
PROTECTOR ...