Nissan Rogue Service Manual: Battery terminal with fusible link
Exploded View
- Cover
- Fusible link box (battery)
- Positive cable
- Battery
- Harness connector
Front
Removal and Installation
REMOVAL
- Loosen battery terminal nuts and disconnect both negative and
positive terminals from the battery.
CAUTION: To prevent damage to the parts, disconnect the battery negative terminal first.
- Disconnect positive cable from fusible link box (battery).
- Disconnect harness connectors from fusible link box (battery) and remove fusible link box (battery).
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Replace the fusible link box battery if it has been dropped or sustained and impact. To install the battery, carefully read the following instructions:
- To prevent damage to the parts, connect the battery cable to the positive terminal first.
- After connecting battery cables, to securely supply battery voltage, ensure that they are tightly
- amped to battery terminals for good contact.
• To securely supply battery voltage, check battery terminal for poor connection caused by corrosion.
Reset electronic systems as necessary. Refer to PG-72, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair Requirement".
Battery
Exploded View
Battery tray liner
Battery frame
Battery
Battery rod
Battery cover
Battery tray
Front
Removal and Installation (Battery)
REMOVAL
Pull back cov ...
Service data and specifications (SDS)
Battery
*: Always check with the Parts Department for the latest parts information. ...
Other materials:
Glove box assembly and housing
Removal and Installation
REMOVAL
Release instrument side finisher (RH) (1) pawls using a suitable
tool and remove.
: Pawl
NOTE:
LH side shown; RH similar.
Release the glove box damper (1) from the glove box assembly
(2) as shown.
Release the glove box assembly pawls ...
C1601 battery power supply
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1601
BATTERY VOLT
When a power supply voltage to the EPS control unit
is maintained at 18.2 V or more or at less than 9 V
continuously for five second ...
Rear-facing child restraint installation using
LATCH
For additional information, refer to all Warnings
and Cautions in the “Child Safety” and “Child
Restraint” sections before installing a child restraint.
NISSAN does not recommend the use of the
lower anchors if the combined weight of the child
and the child restraint exceeds 65 lbs (2 ...
