AIR BAG Warning Lamp Does Not Turn Off
1.CHECK CONDITION OF AIR BAG MODULE
Inspect for any deployed air bag modules or seat belt pre-tensioners.
Are any air bag modules or seat belt pre-tensioners deployed? YES >> Refer to Frontal collision: SR-5, "FOR FRONTAL COLLISION : When SRS is activated in a collision", SR-6, "FOR FRONTAL COLLISION : When SRS is not activated in a collision" or Side and rollover collision: SR-7, "FOR SIDE AND ROLLOVER COLLISION : When SRS is activated in a collision", SR-8, "FOR SIDE AND ROLLOVER COLLISION : When SRS is not activated in a collision".
NO >> GO TO 2.
2.CHECK THE AIR BAG FUSE
Check 10A fuse [No. 32, located in the fuse block (J/B)].
Is the fuse blown? YES >> GO TO 3.
NO >> GO TO 4.
3.CHECK AIR BAG FUSE AGAIN
Replace 10A fuse [No. 32, located in the fuse block (J/B)] and turn ignition switch ON.
Does the fuse blow again? YES >> Replace fuse and harness.
NO >> Inspection End.
4.CHECK AIR BAG DIAGNOSIS SENSOR UNIT
Connect CONSULT.
Is “AIR BAG� displayed on CONSULT? YES >> GO TO 5.
NO >> Visually inspect the air bag diagnosis sensor unit harness connections. If the connections are OK, replace the air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation".
5.CHECK HARNESS CONNECTION
Check for loose connections between the combination meter and the air bag diagnosis sensor unit.
Are there any loose connections? YES >> Properly connect the combination meter and air bag diagnosis sensor unit harness connectors. If AIR BAG warning lamp still does not turn off, replace the wiring harness.
NO >> Replace air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation".
SRS air bag warning lamp does not turn on
Seat belt warning systemRear wiper motor
Exploded View
Rear wiper motor
Back door
Rear wiper motor harness
Removal and Installation
REMOVAL
Remove rear wiper arm. Refer to WW-69, "Removal and Installation".
Remove back door finisher. Refer to INT-38, "Removal and
Installation".
& ...
Component parts
METER SYSTEM
METER SYSTEM : Component Parts Location
Vehicle front
View of the fuel pump and fuel level
sensor inspection hole covers with
the rear seat removed.
View of front engine assembly
No.
Component
Function
1
Combination me ...
Regulatory Information
FCC Regulatory information
CAUTION: To maintain compliance with
FCC’s RF exposure guidelines, use only the
supplied antenna. Unauthorized antenna,
modification, or attachments could damage
the transmitter and may violate FCC regulations.
Operation is subject to the follow ...