Nissan Rogue Service Manual: Seat belt warning system

Nissan Rogue Service Manual / Restraints / SRS Airbag Control System / Symptom diagnosis / Seat belt warning system

Seat Belt Warning System Does Not Function

1.SEAT BELT WARNING LIGHT

Turn ignition switch ON.

Does the seat belt warning lamp come ON? YES >> GO TO 2.

NO >>

Check 10A fuse [No. 13, located in the fuse block (J/B)].
Check seat belt buckle switch (driver seat).
Check harness between combination meter and seat belt buckle switch (driver seat).
Check combination meter. Refer to MWI-29, "Fail-safe".

2.SEAT BELT BUCKLE (DRIVER SEAT)

Fasten the seat belt buckle (driver seat).

Does the seat belt warning lamp go OFF? YES >> GO TO 3.

NO >>

Check seat belt buckle switch (driver seat).
Check harness between combination meter and seat belt buckle switch (driver seat).

3.OCCUPANT CLASSIFICATION SYSTEM

Have a helper sit in the passenger seat.

Does the seat belt warning lamp go ON? YES >> GO TO 4.

NO >>

Check occupant classification system. Refer to SRC-13, "OCCUPANT CLASSIFICATION SYSTEM : System Description".
Check harness between occupant classification control unit and air bag diagnosis sensor unit.

4.SEAT BELT BUCKLE (PASSENGER SEAT) Fasten the seat belt buckle (passenger seat).

Does the seat belt warning lamp go OFF? YES >> System OK.

NO >>

Check seat belt buckle switch (passenger seat).
Check harness between seat belt buckle switch (passenger seat) and air bag diagnosis sensor unit.
Replace air bag diagnosis sensor unit. Refer to SR-26, "Removal and Installation".

SRS air bag warning lamp does not turn off

AIR BAG Warning Lamp Does Not Turn Off 1.CHECK CONDITION OF AIR BAG MODULE Inspect for any deployed air bag modules or seat belt pre-tensioners. Are any air bag modules or seat belt pre-tensioner ...

Ventilation, heater & air conditioner

...

Other materials:

Front wiper drive assembly
Exploded View REMOVAL Cowl top Front wiper drive assembly Removal and Installation REMOVAL Remove cowl top cover. Refer to EXT-25, "Removal and Installation". Disconnect harness connector from front wiper motor. Remove bolts and front wiper driv ...

Diagnosis system (EPS control unit)
CONSULT Function FUNCTION CONSULT can display each diagnostic item using the diagnostic test modes shown following Diagnostic test mode Function ECU identification The part number stored in the control unit can be read. Self diagnostic result Self-diagnosti ...

Glove box lamp
Bulb Replacement WARNING: Do not touch the glass surface of a bulb while it is lit or right after being turned OFF to prevent burns. CAUTION: Do not touch the glass of bulb directly by hand. Keep grease and other oily substances away from bulb surface. Do not leave bulb ...