Nissan Rogue Service Manual: Parking brake switch
Removal and Installation
REMOVAL
- Remove the instrument lower panel LH. Refer to IP-22, "Removal and Installation".
- Disconnect the harness connector from the parking brake switch. Refer to PB-7, "Exploded View".
- Remove the screw and remove the parking brake switch. Refer to PB-7, "Exploded View".
INSTALLATION
Installation is in the reverse order of removal.
CAUTION: Replace the parking brake switch if it has been dropped or sustained an impact.
Adjust the parking brake cable if necessary. Refer to PB-4, "Inspection and Adjustment".
Parking brake rear cable
Removal and Installation
REMOVAL
Remove the center console assembly. Refer to IP-18, "Removal and
Installation".
Remove shift selector. Refer to TM-194, "Removal a ...
Parking brake shoe
Exploded View
Back plate
Parking brake shoe
Brake strut
Return spring
Spring
Return spring to brake strut
Adjuster
Toggle lever
Anti-rattle pin
: Apply PBC ...
Other materials:
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
Uniform tire quality grading
DOT (Department of Transportation) Quality
Grades: All passenger car tires must conform to
federal safety requirements in addition to these
grades.
Quality grades can be found where applicable on
the tire sidewall between tread shoulder and
maximum section width. For example:
Treadwear 200 ...
Ground
Ground Distribution
MAIN HARNESS
ENGINE ROOM HARNESS
ENGINE CONTROL HARNESS
BODY HARNESS
BODY NO. 2 HARNESS
...
