Nissan Rogue Service Manual: Precaution

Nissan Rogue Service Manual / Electrical & power control / LAN System / CAN gateway / Precaution

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system safely is included in the SR and SB section of this Service Manual.

WARNING:

To avoid rendering the SRS inoperative, which could increase the risk of personal injury or death in the event of a collision which would result in air bag inflation, all maintenance must be performed by an authorized NISSAN/INFINITI dealer.
Improper maintenance, including incorrect removal and installation of the SRS, can lead to personal injury caused by unintentional activation of the system. For removal of Spiral Cable and Air Bag Module, see the SR section.
Do not use electrical test equipment on any circuit related to the SRS unless instructed to in this Service Manual. SRS wiring harnesses can be identified by yellow and/or orange harnesses or harness connectors.

PRECAUTIONS WHEN USING POWER TOOLS (AIR OR ELECTRIC) AND HAMMERS

WARNING:

When working near the Airbag Diagnosis Sensor Unit or other Airbag System sensors with the Ignition ON or engine running, DO NOT use air or electric power tools or strike near the sensor(s) with a hammer. Heavy vibration could activate the sensor(s) and deploy the air bag(s), possibly causing serious injury.
When using air or electric power tools or hammers, always switch the Ignition OFF, disconnect the battery and wait at least three minutes before performing any service.

CAN gateway

...

System description

SYSTEM System Description SYSTEM DIAGRAM SYSTEM DESCRIPTION The BCM has a CAN gateway function. The BCM communicates between two CAN communication circuits. The BCM se ...

Other materials:

Power window and door lock/unlock switch RH
Removal and Installation REMOVAL Remove the front door pull handle bracket (RH). Refer to INT-15, "Removal and Installation". Release pawls using a suitable tool (A) and remove front door power window and door lock/unlock switch finisher (RH) (1). : Pawl D ...

U1050, U1051 LIN communication
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition U1050 LIN COMMUNICATION [LIN (Local Interconnect Network) communication)] ECM detects LIN communication error. U1051 POSSIBLE CAUSE ...

System
WARNING CHIME SYSTEM WARNING CHIME SYSTEM : System Description SYSTEM DIAGRAM (WITH INTELLIGENT KEY SYSTEM) SYSTEM DIAGRAM (WITHOUT INTELLIGENT KEY SYSTEM) COMBINATION METER INPUT/OUTPUT SIGNAL (CAN COMMUNICATION SIGNAL) Input signal Output signal BCM INPUT/OUTPUT SIGNAL (CAN ...