Nissan Rogue manuals

Nissan Rogue Service Manual: Personal lamp

Removal and Installation

The personal lamp is serviced as part of headlining. Refer to INT-30, "Removal and Installation".

Bulb or Lens Replacement

WARNING: Do not touch the glass surface of a bulb while it is lit or right after being turned OFF to prevent burns.

CAUTION:

  1.  Insert a suitable tool into the gap between the lens and personal lamp, then gently release the lens pawls and remove.
  2.  Grasp the bulb and pull straight out from its socket to remove.
  3.  Install personal lamp bulb to personal lamp.
  4.  Install the personal lamp lens.
Room lamp
Removal and Installation WARNING: Do not touch the glass surface of a bulb while it is lit or right after being turned OFF to prevent burns. CAUTION:  Do not touch the glass of bulb di ...

Luggage room lamp
Removal and Installation REMOVAL Insert a suitable tool (A) into the gap between the luggage lower finisher (RH) (2) and the top of luggage room lamp (1) to release the pawl. : Pawl ...

Other materials:

System
MOONROOF MOONROOF : System Diagram MOONROOF & SUNSHADE MOONROOF : System Description MOONROOF SYSTEM INPUT/OUTPUT SIGNAL CHART Item Input signal to moonroof motor assembly Moonroof motor function Actuator Moonroof switch Moonroof signal (tilt ...

Door switch
WITH INTELLIGENT KEY WITH INTELLIGENT KEY : Component Function Check 1.CHECK FUNCTION  Select "DOOR LOCK" of "BCM" using CONSULT.  Select "DOOR SW-DR", "DOOR SW-AS", "DOOR SW-RL", "DOOR SW-RR", in "Data Monitor&quo ...

C1105, C1106, C1107, C1108 wheel sensor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1105 RR RH SENSOR-2 When distance between rear wheel sensor RH and rear wheel sensor RH rotor is large.  When installation of rear whe ...

В© 2014-2026 Copyright t32.nirogue.com