Nissan Rogue Service Manual: P1568 signal invalid
DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detecting condition |
| P1568 | ICC COMMAND VALUE (Intelligent cruise control command value) | ECM detects that a throttle valve opening angle request signal sent from chassis control module is difference from the specified value calculated by ECM. |
POSSIBLE CAUSE
- Chassis control module
- ECM
FAIL-SAFE
Active trace control does not function.
DTC CONFIRMATION PROCEDURE
1.CHECK DTC PRIORITY
If DTC P1568 is displayed with DTC UXXXX, first perform the confirmation procedure for DTC UXXXX.
Is applicable DTC detected? YES >> Perform diagnosis for detected DTC. Refer to EC-93, "DTC Index".
NO >> GO TO 2.
2.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
- Turn ignition switch OFF and wait at least 10 seconds.
- Turn ignition switch ON.
- Turn ignition switch OFF and wait at least 10 seconds.
>> GO TO 3.
3.PERFORM DTC CONFIRMATION PROCEDURE
- Turn ignition switch ON and wait at least 5 seconds.
- Check DTC.
Is DTC detected? YES >> Proceed to EC-406, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK DTC PRIORITY
If DTC P1568 is displayed with DTC UXXXX, first perform the confirmation procedure for DTC UXXXX.
Is applicable DTC detected? YES >> Perform diagnosis for detected DTC. Refer to EC-93, "DTC Index".
NO >> GO TO 2.
2.CHECK SELF-DIAGNOSTIC RESULT OF CHASSIS CONTROL MODULE
Check that the chassis control module does not detect any DTC.
Is any DTC detected? YES >> GO TO 2.
NO >> Replace chassis control module. Refer to DAS-277, "Removal and Installation".
3.REPLACE CHASSIS CONTROL MODULE
- Replace chassis control module. Refer to DAS-277, "Removal and Installation".
- Perform DTC Confirmation Procedure again.
Is DTC P1568 detected again? YES >> Replace ECM. Refer to EC-499, "Removal and Installation".
NO >> INSPECTION END
1564 ASCD steering switch
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P1564
ASCD SW
(ASCD switch)
An excessi ...
P1572 brake pedal position switch
DTC Description
DTC DETECTION LOGIC
NOTE:
This self-diagnosis has the one trip detection logic. When malfunction A is
detected, DTC is not stored
in ECM memory. And in that case, 1st trip DTC an ...
Other materials:
Front wiper drive assembly
Exploded View
REMOVAL
Cowl top
Front wiper drive assembly
Removal and Installation
REMOVAL
Remove cowl top cover. Refer to EXT-25, "Removal and
Installation".
Disconnect harness connector from front wiper motor.
Remove bolts and front wiper driv ...
C1199 brake booster
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1199
BRAKE BOOSTER
When brake booster vacuum is approx. 0 kPa (0 mm-
Hg) during engine running.
Harness or connector
Vacuum sensor (brake booster)
...
How to use the [ ] button
For additional information, refer to the separate
Navigation System Owner’s Manual regarding
the “SiriusXM® Travel Link”, and “Traffic” features.
For additional information, refer to “Nissan-
ConnectSM with Mobile Apps” in this section
regarding “My Apps” key.
For ad ...
