Nissan Rogue Service Manual: Front wiper drive assembly
Exploded View
REMOVAL
- Cowl top
- Front wiper drive assembly
Removal and Installation
REMOVAL
- Remove cowl top cover. Refer to EXT-25, "Removal and Installation".
- Disconnect harness connector from front wiper motor.
- Remove bolts and front wiper drive assembly.
INSTALLATION
Installation is in the reverse order of removal.
Front wiper blade
Exploded View
Wiper blade (RH)
Wiper arm (RH)
Wiper arm cover
Front wiper drive assembly
Wiper arm (LH)
Wiper blade (LH)
Removal and Installation
REMOVAL
Move front ...
Front wiper motor
Removal and Installation
REMOVAL
Remove the front drive assembly. Refer to WW-66, "Removal and
Installation".
Remove the bolts (A) from the front wiper drive assembly ( ...
Other materials:
C1101, C1102, C1103, C1104 wheel sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1101
RR RH SENSOR-1
When power supply voltage of rear wheel sensor
RH is low.
When an open or shorted circuit is detected in rear
wheel sensor RH ...
P0520 EOP sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0520
EOP SENSOR/SWITCH
(Engine oil pressure sensor/switch circuit)
Signal voltage from the EOP sensor remains at more than 5.02 V /
less than
...
Changing engine oil
Changing engine oil
Park the vehicle on a level surface and apply
the parking brake.
Start the engine and let it idle until it reaches
operating temperature, then turn it off.
Remove the oil filler cap B by turning it
counterclockwise.
Place a large drain pan u ...
