Nissan Rogue Owners Manual: Manual operation
Fan speed control
Press the fan control buttons 
to manually
control the fan speed.
Press the AUTO button to return to automatic control of the fan speed.
Air recirculation
Press the 
air recirculation
button to recirculate
interior air inside the vehicle. The
indicator light on the button will come on.
The air recirculation cannot be activated when
the air conditioner is in the 
front defrosting
mode.
Fresh air intake
Press the
fresh air intake
button to draw
outside air into the passenger compartment.
The
indicator light on the
button will come
on.
Air flow control
Pressing the MODE button manually controls air flow and selects the air outlet:
— Air flows mainly from center
and
side vents.
— Air flows mainly from center and
side vents and foot outlets.
— Air flows mainly from foot
outlets
and partly from defroster.
— Air flows mainly from defroster
and
foot outlets.
To turn system off
Press the OFF button.
Rear window and outside mirror (if so equipped) defroster button
For additional information, refer to “Rear window and outside mirror (if so equipped) defroster switch” in the “Instruments and controls” section of this manual.
Automatic operation
Cooling and/or dehumidified heating
(AUTO)
This mode may be used all year round as the
system automatically works to keep a constant
temperature. Air flow distribution and fan speed
are also cont ...
Operating tips
When the engine coolant temperature and
outside air temperature are low, the air flow
from the foot outlets may not operate for a
maximum of 150 seconds. However, this is
not a malfunction. ...
Other materials:
Accelerator pedal released position learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor output
signal. It must be performed each
time harness connector of accelerator pedal position sensor ...
P0441 EVAP control system
DTC Description
DTC DETECTION LOGIC
In this evaporative emission (EVAP) control system, purge flow occurs during
non-closed throttle conditions.
Purge volume is related to air intake volume. Under normal purge conditions
(non-closed throttle), the EVAP
canister purge volume control solenoi ...
System description
COMPONENT PARTS
POWER DOOR LOCK SYSTEM
POWER DOOR LOCK SYSTEM : Component Parts Location
No
Component
Function
1
BCM
Controls the door lock system.
Refer to BCS-7, "BODY CONTROL SYSTEM : Component Parts Location" for
detailed
install ...
