Nissan Rogue Service Manual: B2205 vehicle speed

Nissan Rogue Service Manual / Driver information & multimedia / Meter, Warning Lamp & Indicator / DTC/circuit diagnosis / B2205 vehicle speed

Description

Vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) via CAN communication line to combination meter.

DTC Logic

DTC DETECTION LOGIC

DTC	CONSULT	Detection Condition	Possible Cause
B2205	VEHICLE SPEED CIRC [B2205]	Malfunction is detected when an erroneous speed signal is received for 2 seconds or more.	Combination meter ABS actuator and electric unit (control unit)

Diagnosis Procedure

1.CHECK COMBINATION METER INPUT SIGNAL

Start engine and select “METER/M&A” on CONSULT.
Using ”SPEED METER” on ”Data Monitor”, compare the value of Data Monitor with speedometer pointer of combination meter. Speedometer and Data Monitor indications should be close.

Is the inspection result normal? YES >> Perform “Self Diagnostic Result” of “ABS” Refer to BRC-44, "CONSULT Function".

NO >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

U1010 control unit (CAN)

Description Initial diagnosis of combination meter. DTC Logic DTC DETECTION LOGIC DTC CONSULT Detection Condition Possible Cause U1010 CONTROL UNIT (CAN ...

B2267 engine speed

Description The engine speed signal is transmitted from ECM to the combination meter with CAN communication. DTC Logic DTC DETECTION LOGIC DTC CONSULT Detection Conditio ...

Other materials:

Periodic maintenance
HEADLAMP AIMING ADJUSTMENT Inspection PREPARATION BEFORE ADJUSTING Before performing aiming adjustment, check the following: Make sure all tires are inflated to correct pressure. Place vehicle and screen on level surface. Make sure there is no load in vehicle other than ...

How to read the displayed lines
Guiding lines which indicate the vehicle width and distances to objects with reference to the vehicle body line A are displayed on the monitor. Distance guide lines: Indicate distances from the vehicle body. Red line 1 : approx. 0.5 m (1.5 ft) Yellow line 2 : approx. 1 m (3 ...

System
System Description When the vehicle has reached a speed of 40 km/h (25 MPH) or greater, the BCM receives a signal transmitted from the tire pressure sensors installed in each wheel. If the BCM detects low inflation pressure or a system malfunction, it sends a signal to the combination meter v ...