Nissan Rogue Owners Manual: Operating tips

Nissan Rogue Owners Manual / Monitor, climate, audio, phone and voice recognition systems / Heater and Air Conditioner (automatic) (if so equipped) / Operating tips

When the engine coolant temperature and outside air temperature are low, the air flow from the foot outlets may not operate for a maximum of 150 seconds. However, this is not a malfunction. After the coolant temperature warms up, air flow from the foot outlets will operate normally.
Keep the moonroof closed while the air conditioner is in operation.
If you feel that the air flow mode you have selected and the outlets the air is coming out do not match, select the mode.
When you change the air flow mode, you may feel air flow from the feet vents for just a moment. This is not a malfunction.

Operating tips

The sunload sensor, located on the top and center of the instrument panel, helps the system maintain a constant temperature. Do not put anything on or around this sensor.

Manual operation

Fan speed control Press the fan control buttons to manually control the fan speed. Press the AUTO button to return to automatic control of the fan speed. Air recirculation Press the air re ...

Servicing air conditioner

The air conditioner system in your NISSAN vehicle is charged with a refrigerant designed with the environment in mind. This refrigerant does not harm the earth’s ozone layer. Special charging ...

Other materials:

Periodic maintenance
CVT FLUID Inspection FLUID LEAKAGE Check transaxle surrounding area (oil seal and plug etc.)for fluid leakage. If anything is found, repair or replace damaged parts and adjust CVT fluid level. Refer to TM-192, "Adjustment". Replacement Recommended fluid and ...

S connector circuit
Description The starter motor magnetic switch is supplied with power when the ignition switch is turned to the START position while the selector lever is in the P (Park) or N (Neutral) position. Diagnosis Procedure Regarding Wiring Diagram information, refer to STR-7, "Wiring Diagram" ...

Preparation
Special Service Tool The actual shapes of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Tool number (TechMate No.) Tool name — (J-39570) Chassis Ear Locating the noise — (J-50397) NI ...