Nissan Rogue Owners Manual: Hill start assist system

Nissan Rogue Owners Manual / Starting and driving / Hill start assist system

Hill start assist system

WARNING

Never rely solely on the hill start assist system to prevent the vehicle from moving backward on a hill. Always drive carefully and attentively. Depress the brake pedal when the vehicle is stopped on a steep hill. Be especially careful when stopped on a hill on frozen or muddy roads. Failure to prevent the vehicle from rolling backwards may result in a loss of control of the vehicle and possible serious injury or death.
The hill start assist system is not designed to hold the vehicle at a standstill on a hill. Depress the brake pedal when the vehicle is stopped on a steep hill.
Failure to do so may cause the vehicle to roll backwards and may result in a collision or serious personal injury.
The hill start assist may not prevent the vehicle from rolling backwards on a hill under all load or road conditions. Always be prepared to depress the brake pedal to prevent the vehicle from rolling backwards. Failure to do so may result in a collision or serious personal injury

When the vehicle is stopped on a hill, the hill start assist system automatically keeps the brakes applied.

This helps prevent the vehicle from rolling backward in the time it takes the driver to release the brake pedal and apply the accelerator.

Hill start assist will operate automatically under the following conditions:

The shift lever is shifted to a forward or reverse gear.
The vehicle is stopped completely on a hill by applying the brake.

The maximum holding time is two seconds. After two seconds the vehicle will begin to roll back and hill start assist will stop operating completely.

Hill start assist will not operate when the shift lever is shifted into N (Neutral) or P (Park) or on a flat and level road.

Hill Descent Control System (if so equipped)

Hill Descent Control System WARNING Never rely solely on the hill descent control system to control vehicle speed when driving on steep downhill grades. Always drive ...

Cold weather driving

Freeing a frozen door lock To prevent a door lock from freezing, apply deicer through the key hole. If the lock becomes frozen, heat the key before inserting it into the key hole, or use the NISSA ...

Other materials:

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow (With GR8-1200 NI) STARTING SYSTEM DIAGNOSIS WITH GR8-1200 NI To test the starting system, use the following special service tool: GR8-1200 NI Multitasking battery and electrical diagnostic station NOTE: Refer to the diagnostic station Instruc ...

Component parts
METER SYSTEM METER SYSTEM : Component Parts Location Vehicle front View of the fuel pump and fuel level sensor inspection hole covers with the rear seat removed. View of front engine assembly No. Component Function 1 Combination me ...

Occupant classification system control unit
Removal and Installation OCCUPANT CLASSIFICATION SYSTEM CONTROL UNIT WARNING: Before servicing the SRS, turn ignition switch OFF, disconnect both battery terminals then wait at least three minutes. Do not use air tools or electric tools for servicing. Removal Re ...