Fan control dial
The fan control dial turns the fan on and off, and controls fan speed.
Air flow control buttons
The air flow control buttons allow you to select the air flow outlets.
MAX A/C — Air flows mainly from center and
side vents with maximum cooling
and
turns on.
— Air flows mainly from center and
side vents.
— Air flows mainly from center and
side vents and foot outlets.
— Air flows mainly from foot
outlets
and partly from defroster.
— Air flows mainly from defroster
outlets
and foot outlets.
— Air flows mainly from defroster
outlets.
Temperature control dial The temperature control dial allows you to adjust the temperature of the outlet air. To lower the temperature, turn the dial to the left. To increase the temperature, turn the dial to the right.
Air
recirculation button
On position (Indicator light on):
Interior air is recirculated inside the vehicle.
Press the
button to the ON position
when:
Off position (Indicator light off):
Outside air is drawn into the passenger compartment and distributed through the selected outlet.
Use the off position for normal heater or air conditioner operation.
Air conditioner
button
Start the engine, turn the fan control dial to the
desired position and press the
button to
turn on the air conditioner. To turn off the air
conditioner, press the
button
again.
The air conditioner cooling function operates only when the engine is running.
Rear window and outside mirror (if so equipped) defroster button
For additional information, refer to “Rear window and outside mirror (if so equipped) defroster switch� in the “Instruments and controls� section of this manual.
Heater and Air Conditioner (manual)
(if so equipped)
Heater operationP0711 transmission fluid temperature sensor A
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0711
FLUID TEMP SENSOR A
(Transmission Fluid Temperature Sensor A
Circuit Range/Performance)
When any of 1 or 2 is satisfied:
Under the followi ...
When traveling or registering your vehicle in
another country
When planning to drive your NISSAN vehicle
in another country, you should first find
out if the fuel available is suitable for your vehicle’s
engine.
Using fuel with an octane rating that is too low
may cause engine damage. All gasoline vehicles
must be operated with unleaded gasoline. The ...
NISSAN Jackknife key (if so equipped)
Replace the battery in the jackknife key as follows:
Hold jackknife key button side up. Insert a
small screwdriver into the slit of the corner
and twist it to separate the upper part from
the lower part. Use a cloth to protect the
casing.
Remove old battery.
Replace t ...