Nissan Rogue Service Manual: C1770, C1771, C1772, C1773 G sensor
DTC Description
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction Detected Condition | Possible Causes |
| C1770 | G SENSOR FL (G sensor front left) | Malfunction in the G sensor data from front left wheel sensor. |
|
| C1771 | G SENSOR FR (G sensor front right) | Malfunction in the G sensor data from front right wheel sensor. | |
| C1772 | G SENSOR RL (G sensor rear left) | Malfunction in the G sensor data from rear left wheel sensor. | |
| C1773 | G SENSOR RR (G sensor rear right) | Malfunction in the G sensor data from rear right wheel sensor. |
Diagnosis Procedure
1.REPLACE WHEEL SENSOR
When DTC "C1770, C1771, C1772, C1773" is detected, replace wheel sensor.
>> Replace wheel sensor. Refer to BRC-132, "FRONT WHEEL SENSOR : Removal and Installation" (front wheel sensor), BRC-134, "REAR WHEEL SENSOR : Removal and Installation" (rear wheel sensor).
C1769 configuration setting
DTC Description
This procedure must be performed:
After replacement of BCM.
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
C1769
CONFIG SET ...
U1000 CAN COMM CIRCUIT
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellen ...
Other materials:
Throttle valve closed position learning
Description
Throttle Valve Closed Position Learning is a function of ECM to learn the
fully closed position of the throttle
valve by monitoring the throttle position sensor output signal. It must be
performed each time the harness connector
of the electric throttle control actuator or ECM is ...
Heater and Air Conditioner (automatic)
(if so equipped)
Heater and Air Conditioner
(front defroster) button
Temperature control dial (driver’s side) /
ON-OFF button
MODE (manual air flow control) button
Display screen
A/C (air conditioner) button
Temperature control dial (passenger’s
side)/DUAL (pa ...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Workflow
OVERALL SEQUENCE
DETAILED FLOW
1.INTERVIEW CUSTOMER
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction occurred.
>> GO TO 2.
2.SYMPTOM CHECK
Verify symptoms.
...
