DTC Description
This procedure must be performed:
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction detected condition |
| C1769 | CONFIG SETTING (Configuration setting) | Tire air pressure monitoring system configuration cannot be performed. |
| Receiver ID registration cannot be performed. |
Diagnosis Procedure
1.TIRE PRESSURE MONITORING SYSTEM CONFIGURATION
Perform configuration.
>> Refer to WT-21, "Work Procedure", and GO TO 2.
2.TIRE PRESSURE SENSOR ID REGISTRATION
Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure".
Does low tire pressure warning lamp turn OFF? YES >> Inspection End.
NO >> Configuration setting tire pressure monitoring system. Refer to WT-21, "Work Procedure".
C1765, C1766, C1767, C1768 tire pressure sensor
C1770, C1771, C1772, C1773 G sensorSystem description
COMPONENT PARTS
Component Parts Location
View under rear of front passenger
seat
View with spare tire cover removed
Center of back door
View with glove box removed
No.
Component
Function
1
Rod antenna
Refer to AV-232, &quo ...
Low tire pressure warning lamp does not turn on
Low Tire Pressure Warning Lamp Does Not Come On When Ignition Switch Is
Turned
On
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and display TPMS sensor IDs
&n ...
Diagnosis system (BCM) (with intelligent key system)
COMMON ITEM
COMMON ITEM : CONSULT Function (BCM - COMMON ITEM)
APPLICATION ITEM
CONSULT performs the following functions via CAN communication with BCM.
Direct Diagnostic Mode
Description
Ecu Identification
The BCM part number is displayed.
Self Diagnostic ...