Nissan Rogue manuals

Nissan Rogue Owners Manual: Air conditioner operation

Start the engine, turn the fan control dial to the desired position, and press the button to activate the air conditioner. When the air conditioner is on, cooling and dehumidifying functions are added to the heater operation.

The air conditioner cooling function operates only when the engine is running.

Cooling

This mode is used to cool and dehumidify the air.

  1.  Press the air flow control button.
  2.  Turn the fan control dial to the desired position.
  3.  Push the button. The indicator light on the button will come on.
  4.  Turn the temperature control dial to the desired position.

Dehumidified heating

This mode is used to heat and dehumidify the air.

  1.  Press the button to the OFF position.
  2.  Press the air flow control button.
  3.  Turn the fan control dial to the desired position.
  4.  Push the button.
  5.  Turn the temperature control dial to the desired position.

Dehumidified defogging

This mode is used to defog the windows and dehumidify the air.

  1.  Press the air flow control button.
  2.  Turn the fan control dial to the desired position.
  1.  Turn the temperature control dial to the desired position.

Operating tips

Heater operation
Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets.  Press the button to change to fresh air i ...

Air flow charts
The following charts show the button and dial positions for MAXIMUM AND QUICK heating, cooling or defrosting. The air recirculation indicator should always be in the OFF position for heating and d ...

Other materials:

Parking brake shoe
Exploded View Back plate Parking brake shoe Brake strut  Return spring Spring Return spring to brake strut  Adjuster Toggle lever Anti-rattle pin : Apply PBC (Poly Butyl Cuprysil) grease or silicone-based grease Removal and Installation REMOVAL WARNING ...

DTC/circuit diagnosis
U1000 CAN COMM CIRCUIT Description Refer to LAN-8, "System Description". DTC Logic DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual CAN diagnostic symptoms and a present DTC by p ...

Power supply and ground circuit
BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis Procedure Regarding Wiring Diagram information, refer to BCS-50, "Wiring Diagram". 1. CHECK FUSE Check that the following fuse is not blown. Is the fuse blown ...

© 2014-2026 Copyright t32.nirogue.com