Nissan Rogue Service Manual: VIN registration
Description
VIN Registration is an operation to registering VIN in ECM. It must be performed each time ECM is replaced.
NOTE: Accurate VIN which is registered in ECM may be required for Inspection & Maintenance (I/M).
Work Procedure
1.CHECK VIN
Check the VIN of the vehicle and note it. Refer to GI-34, "Identification Number".
>> GO TO 2.
2.PERFORM VIN REGISTRATION
With CONSULT
- Turn ignition switch ON and engine stopped.
- Select “VIN REGISTRATION” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.
- Follow the instruction of CONSULT display.
>> END
Additional service when replacing ECM
Description
When replacing ECM, the following procedure must be performed. (For details,
refer to EC-136, "Work Procedure".)
PROGRAMMING OPERATION
NOTE:
After replacing with a blank EC ...
Accelerator pedal released position learning
Description
Accelerator Pedal Released Position Learning is a function of ECM to learn
the fully released position of the
accelerator pedal by monitoring the accelerator pedal position sensor outp ...
Other materials:
Front wiper drive assembly
Exploded View
REMOVAL
Cowl top
Front wiper drive assembly
Removal and Installation
REMOVAL
Remove cowl top cover. Refer to EXT-25, "Removal and
Installation".
Disconnect harness connector from front wiper motor.
Remove bolts and front wiper driv ...
B142X collision detection
Description
DTC B1209 - B1211 COLLISION DETECTION
The air bag diagnosis sensor unit will set this DTC if it has detected a
collision which has resulted in a deployment
of one or more air bags or pre-tensioners. If this DTC is detected after a SRS
repair, the air bag diagnosis
sensor unit has ...
Preparation
Special Service Tool
Tool number
(TechMate No.)
Tool name
Description
—
(J-46534)
Trim Tool Set
Removing trim components
Commercial Service Tool
(TechMate No.)
Tool name
Description
( — )
Power tool
Loo ...
