Nissan Rogue manuals

Nissan Rogue Owners Manual: Vehicle recovery (freeing a stuck vehicle)

Nissan Rogue Owners Manual / In case of emergency / Towing your vehicle / Vehicle recovery (freeing a stuck vehicle)

Pulling a stuck vehicle

WARNING

To avoid vehicle damage, serious personal injury or death when recovering a stuck vehicle:

  •  Contact a professional towing service to recover the vehicle if you have any questions regarding the recovery procedure.
  •  Attach recovery devices only to main structural members of the vehicle or the recovery hooks.
  •  Do not use the vehicle tie-downs to tow or free a stuck vehicle.
  •  Only use devices specifically designed for vehicle recovery and follow the manufacturer’s instructions.
  •  Always pull the recovery device straight out from the front of the vehicle. Never pull at an angle.
  •  Route recovery devices so they do not touch any part of the vehicle except the attachment point.

If your vehicle is stuck in sand, snow, mud, etc., use a tow strap or other device designed specifically for vehicle recovery. Always follow the manufacturer’s instructions for the recovery device.

Do not use the tie-down hooks for towing or vehicle recovery.

Rocking a stuck vehicle

WARNING
  •  Stand clear of a stuck vehicle.
  •  Do not spin your tires at high speed.

    This could cause them to explode and result in serious injury. Parts of your vehicle could also overheat and be damaged.

If your vehicle is stuck in sand, snow, mud, etc., use the following procedure:

  1.  Turn off the Vehicle Dynamic Control (VDC) system.
  2.  Make sure the area in front and behind the vehicle is clear of obstructions.
  3.  Turn the steering wheel right and left to clear an area around the front tires.
  4.  Slowly rock the vehicle forward and backward.
  1.  If the vehicle cannot be freed after a few tries, contact a professional towing service to remove the vehicle.
Towing recommended by NISSAN
All-Wheel Drive (AWD) models NISSAN recommends that towing dollies be used when towing your vehicle or the vehicle be placed on a flatbed truck as illustrated. CAUTIONDO NOT tow AWD mod ...

Appearance and care
...

Other materials:

P0453 EVAP control system pressure sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0453 EVAP SYS PRES SEN (Evaporative emission system pressure sensor/switch high) An excessively high voltage from the sensor is sent to ECM. ...

Symptom diagnosis
HEATER AND AIR CONDITIONING SYSTEM CONTROL SYMPTOMS Symptom Table SYMPTOM TABLE Symptom Reference Page A/C system does not come on. Go to Trouble Diagnosis Procedure for A/C System. HAC-166, "FRONT A/C CONTROL : Diagnosis Procedure" Air ou ...

CAN system (type 3)
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT Diagnosis Procedure 1.CHECK CONNECTOR  Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal.  Check the following terminals and connectors for damage, bend and loose connection (connector side and harn ...

© 2014-2026 Copyright t32.nirogue.com