Nissan Rogue Owners Manual: Towing your vehicle

Nissan Rogue Owners Manual / In case of emergency / Towing your vehicle

When towing your vehicle, all jurisdictional and local regulations for towing must be followed.

Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NISSAN dealer. Local service operators are generally familiar with the applicable laws and procedures for towing. To assure proper towing and to prevent accidental damage to your vehicle, NISSAN recommends having a service operator tow your vehicle. It is advisable to have the service operator carefully read the following precautions:

WARNING

Never ride in a vehicle that is being towed.
Never get under your vehicle after it has been lifted by a tow truck.

CAUTION

When towing, make sure that the transmission, axles, steering system and powertrain are in working condition. If any of these conditions apply, dollies or a flatbed tow truck must be used.
Always attach safety chains before towing.

For additional information about towing your vehicle behind a recreational vehicle (RV), refer to “Flat towing” in the “Technical and Consumer Information” section of this manual.

If your vehicle overheats

WARNING Do not continue to drive if your vehicle overheats. Doing so could cause engine damage or a vehicle fire. To avoid the danger of being scalded, never rem ...

Towing recommended by NISSAN

All-Wheel Drive (AWD) models NISSAN recommends that towing dollies be used when towing your vehicle or the vehicle be placed on a flatbed truck as illustrated. CAUTIONDO NOT tow AWD mod ...

Other materials:

Front wiper motor ground circuit
Diagnosis Procedure Regarding Wiring Diagram information, refer to WW-22, "Wiring Diagram". 1. CHECK FRONT WIPER MOTOR GROUND CIRCUIT Turn the ignition switch OFF. Disconnect front wiper motor. Check continuity between front wiper motor harness connector and ...

System description
COMPONENT PARTS POWER DOOR LOCK SYSTEM POWER DOOR LOCK SYSTEM : Component Parts Location No Component Function 1 BCM Controls the door lock system. Refer to BCS-7, "BODY CONTROL SYSTEM : Component Parts Location" for detailed install ...

Electrical load signal
Description The electrical load signal (Headlamp switch signal, rear window defogger switch signal, etc.) is transferred via the CAN communication. Component Function Check 1.CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION Turn ignition switch ON. Connect CONSULT and select “DAT ...