Description
A malfunction of brake pedal feel (height or others) is detected when brake pedal is depressed.
Diagnosis Procedure
1.CHECK FRONT AND REAR AXLE
Check that there is no excessive looseness in front and rear axle.
AWD: Refer to FAX-38, "Inspection" (front) or RAX-14, "Inspection" (rear).
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace error-detected parts.
2.CHECK DISC ROTOR
Check disc rotor runout.
Is the inspection result normal? YES >> GO TO 3.
NO >> Refinish the disc rotor.
3.CHECK BRAKE FLUID LEAKAGE
Check fluid leakage.
Refer to BR-8, "Inspection" Is the inspection result normal? YES >> GO TO 4.
NO >> Repair or replace error-detected parts.
4.CHECK BRAKE PEDAL
Check each item of brake pedal. Refer to BR-15, "Adjustment".
Is the inspection result normal? YES >> GO TO 5.
NO >> Adjust each item of brake pedal. Refer to BR-15, "Adjustment".
CHECK BRAKING FORCE
Check brake force using a brake tester.
Is the inspection result normal? YES >> GO TO 6.
NO >> Check each components of brake system.
6.CHECK BRAKE PERFORMANCE
Disconnect ABS actuator and electric unit (control unit) connector so that ABS does not operate. Check that brake force is normal in this condition. Connect harness connectors after checking.
Is the inspection result normal? YES >> Normal NO >> Check each components of brake system.
Excessive operation frequency
The braking distance is longSymptom diagnosis
HEAVY TIGHT-CORNER BRAKING SYMPTOM OCCURS
Description
Heavy tight-corner braking symptom occurs when the vehicle is driven and the
steering wheel is turned fully to
either side after the engine is started.
NOTE:
Light tight-corner braking symptom may occur depending on driving conditions.
...
U1050, U1051 LIN communication
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
U1050
LIN COMMUNICATION
[LIN (Local Interconnect Network) communication)]
ECM detects LIN communication error.
U1051
POSSIBLE CAUSE
...
Basic inspection
COMPONENT INSPECTION
Inspection
AFTER A COLLISION
WARNING:
Inspect all seat belt assemblies including retractors and attaching hardware
after any collision.
NISSAN/INFINITI recommends that all seat belt assemblies in use during a
collision be replaced
unless the collision was minor and t ...