Nissan Rogue manuals

Nissan Rogue Service Manual: U1010 control unit (CAN)

Description

Initial diagnosis of combination meter.

DTC Logic

DTC DETECTION LOGIC

DTC

CONSULT

Detection Condition

Possible Cause

U1010 CONTROL UNIT (CAN) [U1010] When detecting error during the initial diagnosis of the CAN controller of combination meter. Combination meter

Diagnosis Procedure

1.REPLACE COMBINATION METER

When DTC "U1010" is detected, replace combination meter.

>> Replace combination meter. Refer to MWI-82, "Removal and Installation".

U1000 CAN COMM circuit
DTC Logic DTC DETECTION LOGIC DTC CONSULT Detection Condition Possible Cause U1000 CAN COMM CIRC [U1000] When combination meter is not transmitting ...

B2205 vehicle speed
Description Vehicle speed signal is transmitted from ABS actuator and electric unit (control unit) via CAN communication line to combination meter. DTC Logic DTC DETECTION LOGIC DTC ...

Other materials:

Service data and specifications (SDS)
Wheel Bearing Drive Shaft Drive Shaft Specifications *Always check with the Parts Department for the latest parts information. Dynamic Damper Specifications Boot Band Specification ...

Idle air volume learning
Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following conditions: Each time electric throttle control actuator or ECM is replaced.  Idle spee ...

Heated seat switch
Exploded View Center console cup holder Driver heated seat switch  Passenger heated seat switch Switch carrier Pawl Removal and Installation REMOVAL  Remove the center console cup holder. Refer to IP-18, "Exploded View".  Remove screws fro ...

В© 2014-2026 Copyright t32.nirogue.com