Nissan Rogue Service Manual: U1000 CAN COMM circuit
DTC Logic
DTC DETECTION LOGIC
|
DTC |
CONSULT |
Detection Condition |
Possible Cause |
| U1000 | CAN COMM CIRC [U1000] | When combination meter is not transmitting or receiving CAN communication signals for 2 seconds or more. | CAN communication system |
Diagnosis Procedure
1.PERFORM SELF DIAGNOSTIC
- Turn ignition switch ON and wait 2 seconds or more.
- Check “Self Diagnostic Result” of “METER/M&A”.
Is DTC "U1000" displayed? YES >> Refer to LAN-17, "Trouble Diagnosis Flow Chart".
NO >> Refer to GI-41, "Intermittent Incident".
U1010 control unit (CAN)
Description
Initial diagnosis of combination meter.
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT
Detection Condition
Possible Cause
U1010
CONTROL UNIT (CAN ...
Other materials:
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of a
registered key.
Never leave these keys in the vehicle.
FCC Notice:
For USA:
This device complies with part 15 of the
FCC Rules. Operation is subject to the following
two conditions: (1) This device ...
Maximum load limits
Never allow the total trailer load to exceed the
value specified in the “Towing
Load/Specification” chart found in this section.
The total trailer load equals trailer weight plus its
cargo weight.
The maximum Gross Combined Weight Rating
(GCWR) should not exceed the value specified
in ...
Manual operation
Fan speed control
Press the fan control buttons
to manually
control the fan speed.
Press the AUTO button to return to automatic
control of the fan speed.
Air recirculation
Press the air recirculation
button to recirculate
interior air inside the vehicle. The
indicator light on the ...
