Nissan Rogue Owners Manual: Tilt/telescopic steering

Nissan Rogue Owners Manual / Pre-driving checks and adjustments / Tilt/telescopic steering

WARNING

Do not adjust the steering wheel while driving. You could lose control of your vehicle and cause an accident.
Do not adjust the steering wheel any closer to you than is necessary for proper steering operation and comfort.
The driver’s air bag inflates with great force. If you are unrestrained, leaning forward, sitting sideways or out of position in any way, you are at greater risk of injury or death in a crash. You may also receive serious or fatal injuries from the air bag if you are up against it when it inflates. Always sit back against the seatback and as far away as practical from the steering wheel. Always use the seat belts.

Manual operation

Tilt and telescopic operation

Pull the lock lever 1 down:

Adjust the steering wheel forward or backward in direction 3 to the desired position.
Adjust the steering wheel up or down in direction 2 to the desired position.

Push the lock lever 1 up firmly to lock the steering wheel in place.

Fuel-filler door

Opener operation Opener operation The fuel-filler lid release is located below the instrument panel. To open the fuel-filler lid, pull the release. To lock, close the fuel-filler lid securely. ...

Sun visors

Sun visors To block glare from the front, swing down the main sun visor. To block glare from the side, remove the main sun visor from the center mount and swing the visor to the si ...

Other materials:

Power outlets
Instrument Panel 12V OUTLETS The power outlets are for powering electrical accessories such as cellular telephones. They are rated at 12 volt, 120W (10A) maximum. The front and center console power outlets are powered only when the ignition switch is in the ACC (if so equipped) or ON po ...

Wiring diagram
POWER DISTRIBUTION SYSTEM Wiring Diagram ...

Ignition signal
Component Function Check 1.INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES-1 >> With CONSULT: GO TO 2. YES-2 >> Without CONSULT: GO TO 3. NO >> Proceed to EC-470, "Diagnosis Procedure". 2.CHECK IGNITION SIGNAL FUNCTIO ...