Nissan Rogue Service Manual: Preparation
Special Service Tool
The actual shape of the tools may differ from those illustrated here.
| Tool number (TechMate No.) Tool name | Description | |
| KV40107300 ( — ) Boot band crimping tool |
|
Installing boot band |
| KV40107500 ( — ) Drive shaft attachment |
|
Removing drive shaft |
| KV38107900 ( — ) Protector |
|
Installing drive shaft a: 32 mm (1.26 in) dia. |
Commercial Service Tools
| Tool name | Description | |
| Ball joint remover |
|
Removing wheel stud |
| Drive shaft puller |
|
Removing drive shaft joint sub assembly |
| Sliding hammer |
|
Removing drive shaft |
| Power tool |
|
Loosening nuts, screws and bolts |
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONE ...
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or
replace these parts.
×: Applicable ...
Other materials:
P0101 MAF sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0101
MAF SEN/CIRCUIT-B1
(Mass or volume air Flow ″A″ circuit range/
performance)
A high voltage from the sensor is sent to ...
Sensor maintenance
Sensor maintenance
The distance sensor for the FCW system A is
located behind the front bumper.
To keep the FCW system operating properly, be
sure to observe the following:
Always keep the sensor area of the front
bumper clean.
Do not strike or damage the areas around
...
DTC/circuit diagnosis
POWER SUPPLY AND GROUND CIRCUIT
AUDIO UNIT
AUDIO UNIT : Diagnosis Procedure
Regarding Wiring Diagram information, refer to AV-27, "Wiring Diagram".
1.CHECK FUSE
Check that the following fuses are not blown.
Are the fuses blown?
YES >> Replace the blown fuse after repairing t ...
