Nissan Rogue Service Manual: Periodic maintenance
REAR PROPELLER SHAFT
Inspection
APPEARANCE AND NOISE
- Check the propeller shaft tube surface for dents or cracks. If malfunction is detected, replace propeller shaft assembly.
- If center bearing is noisy or damaged, replace propeller shaft assembly.
VIBRATION
If vibration is present at high speed, adjust the propeller shaft phase first.
- Check the propeller shaft for bend and damage. If damaged, replace propeller shaft assembly.
- Perform a cruise test drive to check the propeller shaft for runout. If vibration occurs, separate propeller shaft at electric controlled coupling of final drive; then change the phase between electric controlled coupling stud bolt and propeller shaft by the one bolt hole at a time and install propeller shaft.
- If vibration is still detected, measure propeller shaft runout after removing it. Refer to DLN-101, "Inspection".
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOOTING
NVH Troubleshooting Chart
Use the chart below to find the cause of the symptom. If necessary, repair or
replace these parts.
...
Removal and installation
REAR PROPELLER SHAFT
Exploded View
Center bearing mounting bracket
(upper)
Clip
Propeller shaft assembly
Center bearing mounting bracket
(lower)
: Vehicle front
: N·m (kg-m, f ...
Other materials:
Valve timing control
Exploded View
Valve timing cover
2. O-rings
Intake valve timing intermediate
lock control solenoid valve
Intake valve timing control solenoid
valve
Exhaust valve timing control solenoid
valve
Intake Valve Timing Intermediate Lock Control Solenoid Valve, Intake ...
U1001 CAN comm circuit
Description
CAN (Controller Area Network) is a serial communication line for real time
application. It is an on-vehicle multiplex
communication line with high data communication speed and excellent error
detection ability. Many electronic
control units are equipped onto a vehicle, and each co ...
C1109 power and ground system
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1109
BATTERY VOLTAGE
[ABNORMAL]
When ignition voltage is 10 V or less.
When ignition voltage is 16 V or more.
Harness or connector ...
