Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.
Is the inspection results normal? YES >> INSPECTION END
NO >> Go to TM-181, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC (TCM)
With CONSULT
Is any DTC detected? YES >> Check DTC detected item. Refer to TM-63, "DTC Index".
NO >> GO TO 2.
2.CHECK DTC (COMBINATION METER)
With CONSULT
Check “Self Diagnostic Results� in “METER/M&A�.
Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-30, "DTC Index".
NO >> GO TO 3.
3.CHECK COMBINATION METER INPUT/OUTPUT SIGNAL
With CONSULT
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 4.
4.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Check overdrive control switch circuit. Refer to TM-178, "Diagnosis Procedure".
Overdrive control switch
Shift position indicator circuitPrecaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT
PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG� and “SEAT BELT PRE-TENSIONER�,
used along
with a front seat belt, helps to reduce the risk or severity of injury to the
...
P0779 pressure control solenoid B
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0779
Pressure control solenoid B Inte
When all of the following conditions are satisfied and this state is
maintained
for 0.2 seconds:
T ...
P0506 ISC system
Description
The ECM controls the engine idle speed to a specified level through the fine
adjustment of the air, which is let
into the intake manifold, by operating the electric throttle control actuator.
The operating of the throttle valve is
varied to allow for optimum control of the engine ...