Nissan Rogue Owners Manual: NISSAN vehicle immobilizer system

Nissan Rogue Owners Manual / Starting and driving / Push-Button Ignition Switch (if so equipped) / NISSAN vehicle immobilizer system

The NISSAN Vehicle Immobilizer system will not allow the engine to start without the use of the registered key.

If the engine fails to start using a registered key (for example, when interference is caused by another registered key, an automated toll road device or automatic payment device on the key ring), restart the engine using the following procedure:

Leave the ignition switch in the ON position for approximately 5 seconds.
Place the ignition switch in the OFF or LOCK position, and wait approximately 10 seconds.
Repeat Steps 1 and 2.
Restart the engine while holding the device (which may have caused the interference) separate from the registered key.

If the no start condition re-occurs, NISSAN recommends placing the registered key on a separate key ring to avoid interference from other devices.

NISSAN Intelligent Key® battery discharge (if so equipped)

NISSAN Intelligent Key® battery discharge If the battery of the NISSAN Intelligent Key® is discharged, or environmental conditions interfere with the Intelligent Key operation, start the engi ...

Before starting the engine

Make sure the area around the vehicle is clear. Check fluid levels such as engine oil, coolant, brake fluid, and windshield-washer fluid as frequently as possible, or at least wheneve ...

Other materials:

B1430 seat belt pre-tensioner
DTC Logic DTC DETECTION LOGIC CONSULT name DTC DTC detecting condition Repair order FRONT PRE-TEN LH CIRCUIT [OPEN] B1430 Front LH seat belt pre-tensioner circuit is open. Refer to SRC-59, "Diagnosis Procedure". FRONT PRE-T ...

Divide-n-hide® adjustable floor (if so equipped)
Divide-n-hide® adjustable floor (if so equipped) WARNINGDo not put objects heavier than 165 lbs (75 kg) on the Divide-N-Hide® while in the mid position. In the upper position, objects should not weigh more than 30 lbs (14 kg). There are multiple positions for the adju ...

Power supply and ground circuit
COMBINATION METER COMBINATION METER : Diagnosis Procedure Regarding Wiring Diagram information, refer to MWI-32, "Wiring Diagram". 1.CHECK FUSES Check that the following fuses are not blown. Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circu ...