Nissan Rogue Service Manual: Inspection and adjustment
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement
INITIALIZATION PROCEDURE
Moonroof
If the moonroof does not open or close automatically, use the following procedure to return moonroof operation to normal.
- Turn ignition switch ON.
- Push and hold the moonroof switch forward until the moonroof and sunshade stop and bounce back.
- Release the moonroof switch.
- Press and hold the moonroof switch within 6 seconds.
- The roof glass and shade will move to full open and back to full close.
- Release the switch, initialization is complete if the moonroof operates normally.
ANTI-PINCH FUNCTION
Moonroof/Sunshade
- Fully open the moonroof to the full open position.
- Place a piece of wood at the fully closed position.
- Close the moonroof completely with auto-slide close function.
- Moonroof should make contact and then tilt up or travel in reverse.
CAUTION: • Do not test the anti-pinch function with your hands or other body parts because they may be pinched.
• Depending on the environment and driving conditions, if a similar impact or load is applied to the moonroof it may lower.
• Test the auto-slide operation before inspection when the initialization procedure is performed.
• Perform the initialization procedure when the auto-slide operation or anti-pinch function does not operate normally.
Diagnosis and repair workflow
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1. OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
whic ...
Other materials:
Unit removal and installation
TRANSAXLE ASSEMBLY
Exploded View
Transaxle assembly
O-ring
CVT fluid charging pipe
CVT fluid charging pipe cap
For the tightening torque, refer to TM-220, "Removal and
Installation".
Always replace after every
disassembly.
: N·m (kg-m, ft-lb)
: N·m ...
Rear window wiper and washer switch
WARNINGIn freezing temperatures the washer solution
may freeze on the window and obscure
your vision. Warm the rear window
with the defroster before you wash the
rear window.
CAUTION
Do not operate the washer continuously
for more than 30 seconds ...
Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW
Work Flow (With GR8-1200 NI)
STARTING SYSTEM DIAGNOSIS WITH GR8-1200 NI
To test the starting system, use the following special service tool:
GR8-1200 NI Multitasking battery and electrical diagnostic station
NOTE:
Refer to the diagnostic station Instruc ...
