Nissan Rogue Owners Manual: Door locks/unlocks precaution

Nissan Rogue Owners Manual / Pre-driving checks and adjustments / NISSAN Intelligent Key® (if so equipped) / Door locks/unlocks precaution

Door locks/unlocks precaution

Do not push the door handle request switch with the Intelligent Key held in your hand as illustrated. The close distance to the door handle will cause the Intelligent Key system to have difficulty recognizing that the Intelligent Key is outside the vehicle.
After locking with the door handle request switch, verify the doors are securely locked by testing them.
To prevent the Intelligent Key from being left inside the vehicle, make sure you carry the Intelligent Key with you and then lock the doors.
Do not pull the door handle before pushing the door handle request switch. The door will be unlocked but will not open. Release the door handle once and pull it again to open the door.

Operating range

Operating range The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1 . When the Intelligent Key battery i ...

NISSAN Intelligent Key® Operation

NISSAN Intelligent Key® Operation You can lock or unlock the doors without taking the Intelligent Key out of your pocket or bag. When you carry the Intelligent Key with you, you can lock or ...

Other materials:

P0014 EVT control
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0014 EXH/V TIM CONT-B1 (″B″ Camshaft position - timing over-advanced or system performance bank 1) There is a gap between angle of ...

Accelerator pedal released position learning
Description Accelerator Pedal Released Position Learning is a function of ECM to learn the fully released position of the accelerator pedal by monitoring the accelerator pedal position sensor output signal. It must be performed each time harness connector of accelerator pedal position sensor ...

Ignition signal
Component Function Check 1.INSPECTION START Turn ignition switch OFF, and restart engine. Does the engine start? YES-1 >> With CONSULT: GO TO 2. YES-2 >> Without CONSULT: GO TO 3. NO >> Proceed to EC-470, "Diagnosis Procedure". 2.CHECK IGNITION SIGNAL FUNCTIO ...