Nissan Rogue Service Manual: C1765, C1766, C1767, C1768 tire pressure sensor
DTC Description
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction Detected Condition | Possible Cause |
| C1765 | WHEEL TOP DATA FL (Wheel top data front left) | Malfunction in the wheel top data from the front LH wheel speed sensor. | Wheel speed sensor |
| C1766 | WHEEL TOP DATA FR (Wheel top data front right) | Malfunction in the wheel top data from the front RH wheel speed sensor. | |
| C1767 | WHEEL TOP DATA RR (Wheel top data rear right) | Malfunction in the wheel top data from the rear RH wheel speed sensor. | |
| C1768 | WHEEL TOP DATA RL (Wheel top data rear left) | Malfunction in the wheel top data from the rear LH wheel speed sensor. |
Diagnosis Procedure
1.PERFORM ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT) SELF-DIAGNOSIS
When DTC "C1765, C1766, C1767, C1768" is detected, perform ABS system diagnosis.
>> Perform ABS system diagnosis. Refer to BRC-55, "DTC Index".
C1735 ignition signal
DTC Logic
NOTE:
The Signal Tech II Tool [- (J-50190)] can be used to perform the following
functions. Refer to the Signal Tech II
User Guide for additional information.
Activate and dis ...
C1769 configuration setting
DTC Description
This procedure must be performed:
After replacement of BCM.
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
C1769
CONFIG SET ...
Other materials:
Unit disassembly and assembly
FRONT COMBINATION LAMP
Exploded View
Front combination lamp
Parking (side marker) lamp bulb socket
Headlamp (low beam) bulb
Plastic cover
Headlamp (high beam) bulb
Turn signal lamp bulb socket
Disassembly and Assembly
DISASSEMBLY
Remove front combinat ...
Consult/gst checking system
Description
NOTE:
This vehicle is diagnosed using the CONSULT-III plus.
When CONSULT is connected with a data link connector equipped
on the vehicle side, it will communicate with the control unit
equipped in the vehicle and then enable various kinds of diagnostic
tests.
Ho ...
Normal operating condition
Description
FRONT WIPER PROTECTION FUNCTION
IPDM E/R detects front wiper stop position by a front wiper stop position
signal.
When a front wiper stop position signal is in the conditions listed below, IPDM
E/R stops power supply to wiper
after repeating a front wiper 10 seconds activation ...
