Nissan Rogue Service Manual: C1606 EPS motor
DTC Logic
DTC DETECTION LOGIC
|
DTC |
Display item |
Malfunction detected condition |
Possible cause |
| C1606 | EPS MOTOR | When the motor driver malfunction of EPS control unit or EPS motor malfunction is detected. |
|
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
>> GO TO 2.
2.DTC REPRODUCTION PROCEDURE
With CONSULT
- Turn the ignition switch OFF to ON.
- Perform “EPS” self-diagnosis.
Is DTC “C1606” detected? YES >> Proceed to diagnosis procedure. Refer to STC-24, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.PERFORM SELF-DIAGNOSIS
With CONSULT
- Erase self-diagnostic results for “EPS”.
- Turn the ignition switch OFF, and then wait 10 seconds and more.
- Perform self-diagnosis for “EPS”.
Is DTC “C1606” detected? YES >> EPS motor is malfunctioning. Replace steering column assembly. Refer to ST-12, "Removal and Installation".
NO >> Check EPS control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace malfunctioning parts.
C1604 torque sensor
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1604
TORQUE SENSOR
When torque sensor output signal is ma ...
C1607, C1608 EPS control unit
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1607
EEPROM
When the memory (EEPROM) system malfunction i ...
Other materials:
Wiring diagram
BCM
Wiring Diagram
...
C1770, C1771, C1772, C1773 G sensor
DTC Description
DTC DETECTION LOGIC
DTC
Display Item
Malfunction Detected Condition
Possible Causes
C1770
G SENSOR FL
(G sensor front left)
Malfunction in the G sensor data from front left wheel sensor.
Tire pressure sensor
Tire pressure rece ...
Passenger compartment
CAUTIONNever use a fuse of a higher or lower
amperage rating than specified on the
fuse box cover. This could damage the
electrical system or cause a fire.
If any electrical equipment does not operate,
check for an open fuse.
NOTE:
The fuse box is located on the driver ...
