Initialization
When the ignition switch is in the ON position,
NISSAN Voice Recognition is initialized, which
takes a few seconds. When completed, the system
is ready to accept voice commands. If
the
button is pressed before the
initialization
completes, the system will announce: “Voice
Recognition System not ready. Please wait.”

Giving voice commands
button.Available commands are discussed elsewhere in this section.
button to
return to the previous
screen.
button. The system
will announce:
“Cancelling voice recognition” or
“Go back” depending on the current menu
level.
button to
move back
through the menus displayed on the screen.
]
button.Operating tips
To get the best performance out of NISSAN Voice Recognition, observe the following:
NISSAN Voice Recognition System
(if so equipped)
System featuresIgnition coil
Exploded View
Ignition coil
Spark plug
Rocker cover
Removal and Installation
REMOVAL
Remove air duct assembly. Refer to EM-24, "Exploded View" .
Disconnect the harness connector from the ignition coil.
Remove the ignition coil.
CAUTION:
...
C1155 brake fluid level switch
DTC Logic
DTC DETECTION LOGIC
DTC
Display Item
Malfunction detected condition
Possible causes
C1155
BR FLUID LEVEL LOW
When brake fluid level low signal is detected
Harness or connector
ABS actuator and electric unit
(control unit)
  ...
System
SRS AIR BAG SYSTEM
SRS AIR BAG SYSTEM : System Description
SYSTEM DIAGRAM
DESCRIPTION
The air bag deploys if the air bag diagnosis sensor unit is
activated while the ignition switch is in the ON or
START position.
The collision modes for which supplemental restraint sys ...