Nissan Rogue manuals

Nissan Rogue Owners Manual: Towing a trailer

WARNING

Overloading or improper loading of a trailer and its cargo can adversely affect vehicle handling, braking and performance and may lead to accidents.

 

CAUTION
  •  Do not tow a trailer or haul a heavy load for the first 500 (805 km). Your engine, axle or other parts could be damaged.
  •  For the first 500 miles (805 km) that you tow a trailer, do not drive over 50 mph (80 km/h) and do not make starts at full throttle. This helps the engine and other parts of your vehicle wear in at the heavier loads.

Your new vehicle was designed to be used primarily to carry passengers and cargo. Remember that towing a trailer places additional loads on your vehicle’s engine, drive train, steering, braking and other systems.

A NISSAN Towing Guide (U.S. only) is available on the website at www.nissanusa.com. This guide includes information on trailer towing capability and the special equipment required for proper towing.

Loading tips
The GVW must not exceed GVWR or GAWR as specified on the F.M.V.S.S./C.M.V.S.S. certification label. Do not load the front and rear axle to the GAWR. Doing so will exceed the GVWR. ...

Maximum load limits
Never allow the total trailer load to exceed the value specified in the “Towing Load/Specification” chart found in this section. The total trailer load equals trailer weight plus its cargo w ...

Other materials:

Towing load/specification
TOWING LOAD/SPECIFICATION CHART     U.S. and Canada Maximum Towing Capacity*1 1,100lb. (500 kg) Maximum Tongue Load 110 lb. (50 kg) Maximum Gross Combined Weight Rating 5,291 lb. (2,400 kg) *1: The towing capacity ...

Rear LH side power window does not operate
WITH BOTH POWER WINDOW MAIN SWITCH AND REAR POWER WINDOW SWITCH LH WITH BOTH POWER WINDOW MAIN SWITCH AND REAR POWER WINDOW SWITCH LH : Diagnosis Procedur 1.CHECK REAR POWER WINDOW SWITCH Check rear power window switch. Refer to PWC-36, "Component Function Check". Is the inspect ...

Normal operating condition
Description FRONT WIPER PROTECTION FUNCTION IPDM E/R detects front wiper stop position by a front wiper stop position signal. When a front wiper stop position signal is in the conditions listed below, IPDM E/R stops power supply to wiper after repeating a front wiper 10 seconds activation ...

© 2014-2026 Copyright t32.nirogue.com