Nissan Rogue manuals

Nissan Rogue Owners Manual: Flat towing for All–Wheel drive vehicle (if so equipped)

Nissan Rogue Owners Manual / Technical and consumer information / Towing a trailer / Flat towing for All–Wheel drive vehicle (if so equipped)

Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home.

CAUTION
  •  Failure to follow these guidelines can result in severe transmission damage.
  •  Whenever flat towing your vehicle, always tow forward, never backward.
  •  DO NOT tow your All-wheel drive (AWD) vehicle with any wheels on the ground.

    Doing so may cause serious and expensive damage to the powertrain.

  •  For emergency towing procedures refer to “Towing recommended by NISSAN” in the “In case of emergency” section of this manual.
Towing safety
Trailer hitch Your vehicle may be equipped with an optional trailer tow package. The trailer tow package includes a receiver-type frame mounted hitch. This hitch is rated for the maximum towing ca ...

Flat towing for front wheel drive vehicle (if so equipped)
Towing your vehicle with all four wheels on the ground is sometimes called flat towing. This method is sometimes used when towing a vehicle behind a recreational vehicle, such as a motor home. ...

Other materials:

Diagnosis system (BCM) (without intelligent key system)
COMMON ITEM COMMON ITEM : CONSULT Function (BCM - COMMON ITEM) APPLICATION ITEM CONSULT performs the following functions via CAN communication with BCM. Direct Diagnostic Mode Description Ecu Identification The BCM part number is displayed. Self Diagnostic ...

U1044 ENG comm circuit
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition U1044 ENG COMM CIRCUIT (Engine communication circuit A signal voltage of LIN communication between ECM and generator is excessively low or e ...

Additional service when replacing ECM
Description When replacing ECM, the following procedure must be performed. (For details, refer to EC-136, "Work Procedure".) PROGRAMMING OPERATION NOTE: After replacing with a blank ECM, programming is required to write ECM information. Be sure to follow the procedure to perform t ...

© 2014-2026 Copyright t32.nirogue.com