Nissan Rogue manuals

Nissan Rogue Service Manual: The parking brake release warning continues displaying, or does not display

Nissan Rogue Service Manual / Driver information & multimedia / Meter, Warning Lamp & Indicator / Symptom diagnosis / The parking brake release warning continues displaying, or does not display

Description

Diagnosis Procedure

1.CHECK PARKING BRAKE WARNING LAMP OPERATION

  1.  Start engine.
  2.  Check the operation of the brake warning lamp while operating the parking brake.

Check parking brake warning lamp operation

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

NO >> GO TO 2.

2.CHECK PARKING BRAKE SWITCH SIGNAL CIRCUIT

  1.  Turn ignition switch OFF.
  2.  Check the parking brake switch signal circuit. Refer to MWI-64, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness or connector.

3.CHECK PARKING BRAKE SWITCH UNIT

Check the parking brake switch. Refer to MWI-64, "Component Inspection".

Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

NO >> Replace parking brake switch. Refer to PB-7, "Exploded View".

The oil pressure warning continues displaying, or does not display
Description The low oil pressure warning message stays on when oil pressure is normal.  The low oil pressure warning message stays off when oil pressure is low. Diagnosis Procedure ...

The low washer fluid warning continues displaying, or does not display
Description The warning is still displayed even after washer fluid is added. The warning is not displayed even though the washer tank is empty. Diagnosis Procedure 1.CHECK WASHER FLUID LEVEL ...

Other materials:

Service data and specifications (SDS)
Wheel Bearing Drive Shaft Drive Shaft Specifications *Always check with the Parts Department for the latest parts information. Dynamic Damper Specifications Boot Band Specification ...

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Workflow OVERALL SEQUENCE DETAILED FLOW 1.INTERVIEW CUSTOMER Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.SYMPTOM CHECK Verify symptoms. ...

Calibration of decel G sensor
Description CAUTION: Always perform the decel G sensor calibration before driving when the following operation is performed. NOTE: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration. Work Procedure Decel G sensor calibration CAUTION: ...

В© 2014-2026 Copyright t32.nirogue.com