Nissan Rogue manuals

Nissan Rogue Service Manual: Sunshade system does not operate properly

Diagnosis Procedure

1.CHECK BCM POWER SUPPLY AND GROUND CIRCUIT

Check BCM power supply and ground circuit.

Refer to BCS-68, "Diagnosis Procedure" (with Intelligent Key System), BCS-128, "Diagnosis Procedure" (without Intelligent Key System).

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2.CHECK SUNSHADE MOTOR ASSEMBLY POWER SUPPLY AND GROUND CIRCUIT

Check sunshade motor assembly power supply and ground circuit.

Refer to RF-29, "SUNSHADE MOTOR ASSEMBLY : Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace the malfunctioning parts.

3.CONFIRM THE OPERATION

Confirm the operation again.

Is the result normal? YES >> Check intermittent incident. Refer to GI-41, "Intermittent Incident".

NO >> GO TO 1.

Moonroof does not operate properly
Diagnosis Procedure 1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. Refer to BCS-68, "Diagnosis Procedure" (with Intelligent Key System), BCS-128 ...

Auto operation does not operate
MOONROOF MOONROOF : Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repai ...

Other materials:

Rear suspension ARM
Exploded View Rear suspension arm Rubber washer (LH/RH) Rear suspension arm bracket Rear suspension arm stay Front Removal and Installation REMOVAL  Remove the wheel hub and bearing. Refer to RAX-16, "Removal and Installation". Remove the coil spring. R ...

Stall test
Work Procedure INSPECTION  Check the engine oil level. Replenish if necessary. Refer to LU-7, "Inspection".  Check for leak of the CVT fluid. Refer to TM-190, "Inspection".  Drive for about 10 minutes to warm up the vehicle so that the CVT fluid temp ...

Forward-facing child restraint installation using the seat belts
WARNINGThe three-point seat belt with Automatic Locking Retractor (ALR) must be used when installing a child restraint. Failure to use the ALR mode will result in the child restraint not being properly secured. The restraint could tip over or be loose and cause injury to a c ...

В© 2014-2026 Copyright t32.nirogue.com